OK I GOT ANOTHER FLOOR SHIFTER WITH GOOD LINKAGES AND WHEN I HOOKED IT TO MY 203 IT STILL WONT SHIFT INTO THE 4X4 GEARS ==censor ==censor ==censor. THE T-CASE IS GOOD CAUSE IF I UNHOOK THE LINKAGES THEN I CAN MANUALY PUT IT INTO 4HI 4LO AND SO ON MYSELF. BUT AS SOON AS I HOOK UP THE SHIFTER ITS LIKE THE SHIFTER IS JAMED!! THIS IS THE SECOND TIME IVE TRIED THIS AND IM GOING CRAZY!! I KNOW YOUR SUPPOSED TO ADJUST THEM BUT IVE TRIED EVERYTHING!!! IS THERE A TRICK TO GETTING THEM JUST RIGHT THAT I DONT KNOW ABOUT?? ...............PLEASE HELP!!! THIS IS FOR MY 75 CHEVY IM FIXING UP AND IM TRYING TO GET EVERYTHING BACK TO THE WAY IT WAS SO I NEED THIS SHIFTER TO WORK RIGHT.
ARE YOU IN PARK / NEUTRAL WHEN ITS IN A GEAR DRIVE 1ST DOES T CASE GRIND AND THE HOLE IN THE FLOOR PAN IS BIG ENOUGH SO YOUR HANDLE ISN;T HITTIN IF YOU LIFT THE BODY UP YOU NEED TO OPEN UP THE FLOOR PAN HELP?
no when i put the t-case in gear by myself the truck will drive down the road no problem. but when i hook up the linkages to the t-case then try to shift the case with the shifter the shifter wont budge. its like the shifter is stuck.
OK ARE THEY HOOKED UP FOR THE RIGHT DIRECTION PULL BOLTS AREN'T HITTING EACH OTHER COTTER PIN BUT YOU ARE TRYING TO SHIFT THE T CASE INTO GEAR WILL IN NEUTRAL AND STILL NO MOVEMENT AND TO YOU HAVE TO PUSH THE LEVER NOB OVER TO ONE SIDE THEN PULL LIKE ON THE 208s I DONT KNOW BUDDY I'LL LOOK AT MINE LATER YOU GOT 2 BOLTS HOLDIN IT TO THE TRANS
I had the same problem with mine when I put it in the jeep I had to disasemble the shifter so I could clean and lube everything real good. ==shrug
ya both linkages are on right and not hitting each other and i poured alot of oil down into the linkage box but the shifter still wont budge into any other spot. it acts like its stuck. im going crazy trying to figure this out lol.
YA I LOOKED AT 1 TODAY IT ALSO ONLY WANTED TO MOVE 1 SIDE
them shifters were junk from the get go for them cases the last one i had i tore 6 shifters apart to make 1 good shifter and like mudbuster said they need to be cleanedup good and lubed up good
ok ill take it apart tomorrow and go threw the hole thing and grease the hell out of it and see what happenes. thanks again guys for all the advice!
those things suck...lol i hate mine
I wished you lived closer......cause i'd drop over and look at it for ya.............its hard for me tell you what might be wrong with it without being there myself to see.
I have a 76 K20 and 79 K10 with 203's............and I've never had problems not being able to shift them.
This has to be a simple fix.