Yea I an piss poor broke and I just picked it up.
Not a Bad little truck for what I paid. Plus dropping a good battery into it make a big difference as well.
Any one else have one of them? I am looking at some of the Hop-Ups out there but Not a lot of stuff. Still need to Check with RPM but Man its fun little truck. Just want to make it better.
Also Dropped off my Rustler to get the ESC and Motor up graded to the Brushless set up. Only ran the truck 4 or 5 time and the ESC took a dump. Thing would only run in Reverse. Oh well Still a good deal. Was cheaper to do the Brushless set up then to buy a new ESC.
(http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0779.jpg) (http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0779.jpg)
sweet you got any pic's of the duratrax i had a evader both electric and nitro there are hopup out there call ryder hobby in grand rapids they use to stock lots of duratrax stuff and they will send the part to you also twisted rc.com is a good place to order stuff for it
I will have some pics of it in a few days. Ran it 3 or 4 times and the Rear Diff housing broke in to three pieces. Sucks but I need to send the housing back for a spare. Thank you for the one year replacement plain.
haha yeah its nice to get free parts
I just got the new parts in and it all back in one piece. I will post some up later tomorrow.
Just drop 40 buck into it in the past week to get it all fixed up. I destroyed the Trans in it twice in a weekend. Now its all better.
Need to get a pic or two of it.
The R/C holding pen.
(http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0773.jpg) (http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0773.jpg)
My Work station.
(http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0774.jpg) (http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0774.jpg)
My rustler as well.
(http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0775.jpg) (http://i26.photobucket.com/albums/c148/cannaert/XXX-S/DSCF0775.jpg)
i had one a long time ago than i got my revo. it was a fun truck
It not bad but It keeps braking down.
The ESC just took a Dump on it so Now I have to send it in and get it swapped out.
that stinks just make it brushless!
I would but its not worth it on this one.
brushless would kill that rc you need the updated i think ex2 trans its all steel gear
I did all the EX2 guts in my Trans. I burned up to idler gears in it already. Put some sway bars on it as well. Glad I did that b/c it handles alot better and it no longer rolls over like it did before I put them on.
do you have your slipper clutch set if its too tigh when you land from a jump or go fwd rev fast you want to have a little bit of slip in it that will save gears alot seet it so it slips from a dead stop for about a foot then tightin it a half turn that way when theres a shock to the gears it wont be so bad on the trans i had that problem with my losi xxt
It fine now. With the gear all metal now and it have bearings instead of bushings it works great.
any other hop ups?
i like my little truck its a old traxxs stampede electric with a few hipe parts havent played with it in a while
I put a Venom 17 turn motor in it with a Novac ESC and a Savox Servo and a Graphite servo hold down. That is the only hope ups that I have done to it and that will be it untill my Kid breaks it again.