I want to put a roll pan on my 88 blazer. I have yet to find one that's for an '88 blazer'
All I can find are ones for c/k pickups. I was just wondering if the bed width was the same, or if the rear of the trucks were the same. And pretty much just asking if a roll pan for say an 85c/k1500 will fit my blazer.
Thanks.
No one knows?
I got a 85 truck.....what measurements you need?
Unfortunately I don't have the truck to measure. I was just hoping someone knew. I just don't want a rear bumber, and I just want that piece of sheet metal or fiberglass to replace the gap at the bottom between the fenders, below the tailgate
And it doesn't 'have' to be an 85. I was just curious if it would be the same for any square body pickup. Because I know people will put a pickup tailgate in a blazer, so I know that width is the same? But I'm not sure if the roll pan for one will fit a blazer
Better yet, has anyone put a roll pan on a k5?
Id assume theyre the same as everything else is interchangeable between the two. But nvr done it myself
Quote from: HOSS on April 24, 2014, 08:02:48 AM
Id assume theyre the same as everything else is interchangeable between the two. But nvr done it myself
I actually don't think I can? The frame on the blazer sticks out past the tailgate.
Hmmm chop it off? Jk lol nvr noticed that b4
Cut the frame rails down and I bet it will fit