Welding, Fab work, Hydraulics stuff

[Eroq]

I'm looking to do some welding jobs for my fellow  members..

I can do driveshafts, weld up rollcages (if you bend them up), suspensions, bumpers, hitch mounts, and a ton more. If you dont know if it could be done ASK me!

Due to the recent actions of Bogginboy, i will be requiring a 50% deposit before i build your item (This is to protect the investment i make to build it) Your check will NOT be cashed until your item has been completed and you are satisfied with the work

Driveshaft shortening: $50
Driveshaft Lengthening: You supply new shaft center and yokes $50. I supply shaft, you supply yokes $100
Bumpers starting at $75-150 (depending on steel type, and design), will do a package deal for front and rear bumpers. Add 2 Drings (15,000lb) for $50, 2" reese hitch reciever for $50
Hydraulic steering: will set up for $200 if you supply power steering pump, steering valve, steering collum, and hydraulic ram

Will install at no charge if you bring the vehicle to me.

I can currently build parts, ready to install for the following vehicles:
Chevy/GMC
Gen 1 S-Series trucks 83-94
Gen 2 S series trucks 95-04
Full Size 89(era trucks) not sure off the top of my head

CJ-7s
XJ's 88 and 2000 available to me

Anything else just ask!

If you break ANY of my parts due to lack of workmanship i will replace them for FREE


Few of the parts i offer done within a week...

CJ-7 Front and Rear bumpers
98+ S10/S15 front bumper Starting at $75


95-97 S10/S15 front bumper Starting at $100 (will get up-to-date pictures later, this was in mid progress)


Hitch Install $50 you supply the hitch

[Eroq]

[MORGZILLA!]

i need you to make me some bumpers soon remind me to ask you about it tomorrow!!!

[Eroq]

[trogdor48430]

how much to make a rear bumper for a 92 xj with one or two tow points pm me cause ill forget about this lol

[theBroken]

I need some very light cutting and welding done for a hi-lift jack mount bracket for my roof rails. I already have the materials and measurements taken/drawn on the metal.  Give me a call I can stop by sometime. -brodie 248 877 8932.

[MOOSE13]

could u supply the parts for Hydraulic steering and if yes how much for everything

[Eroq]

does the $50 include the drings and putting them on

yes

would you be able to weld them on a round bumper

yes

could u supply the parts for Hydraulic steering and if yes how much for everything

i COULD but, i dont like to do it out of my pocket... i've had people make me build something for them only to not show up for it......

[MOOSE13]

i dont really know what to get as far as parts so what is a ballpark figure for the cost for all the parts

[Eroq]

200~ steering valve
75 valve steering collum
100 cylinder
100 hoses and fittings

plus cooler, remote resivour, fluid

[trogdor48430]

how much for a front and rear bumper combo for a 93 xj with d rings and pics or drawing of what it would look like thanks and how would u fasten them thanks