t case question

[Captn. J]

i have a project where i have to decide what t case i ll need to run and what parts to chase , this will be real short based  like cj5 , i m running a toyota axle which is pass side drop ... and i m planning use 400  and which i already have adapter for a 300 and a  few other t case . problem i dont have the output shaft to change the trans to a 23 spline  that the 400 has 32 spline  right now .... my question  what t case has 32 spline that re small as dana 300 or 20 that i dont have to mess with the output shaft on the th400....

[betterbeaters]

I would use a dana 20 if it was me thats what I used in my cj5

[dogred]

i have the steel adapter that is directly behind 400 trans., then holes drilled to mount alluminum transfercase to that is to passenger side.

[BigFrank]

[BigFrank]

looks like this will work drill a hole er two  23 spline on the input side  the 2 will bolt together as is but the holes will be pointing towards the d side frame rail

[Captn. J]

what u mean bigfrank ?  i have a adapter that goes on 400 to a dana 300  but the problem is that the output shaft is 32 spline and the dana 300 is  a 23 spline input

[Captn. J]

did a few research i think this is what i need

http://www.advanceadapters.com/products/dana-300-input-shaft-with-a-32-splines/

[dogred]

 i have adapter and alluminum type transfercase that were mounted on 400 and were to passenger side,,,,

[Blazin40s]

That's deff. What u need

did a few research i think this is what i need

http://www.advanceadapters.com/products/dana-300-input-shaft-with-a-32-splines/

[Captn. J]

yeah i think thats what i m gonna do ...