Just got the engine back from the machine shop,
.030 over
Recon ford rods
Ground and balanced crank
Speed Pro Performance Hypereutectic Pistons
Clevite Bearings
High Performance Camshaft
Comp Cams Roller Hydraulic lifters
Rebuilt Cast Iron Ford Heads
Federal Mogal High Volume Oil Pump
K&N Cold Air Intake
MSD Ignition (Coil, Distributor, Wires)
4inch BDS suspension lift
3inch Body Lift
17 inch M/T Classic Wheels
Dana 44 Front IFS
Ford 8.8 Rear With New HD Posi Unit Installed
Yukon HD Axle Shafts
SOON TO COME.....
Shift Kit
Hartland Sharp Full Roller Rockers
Might Get a 6Inch Lift For It
NEW TIRES
any suggestions for my new project?
Nice Ride applaudd
==cl Looks like a clean truck to start with.
Big Block and 2.5 tons.....
==cl
Quote from: lilwagon on March 06, 2010, 11:06:44 PM
Quote from: Mac Henderson on March 06, 2010, 12:29:09 PM
Big Block and 2.5 tons.....
it'll get there eventually
Put your body on "Big Bad John", I'll put lil wagon on your frame......
should have the engine out tomorrow, The gasket set for the new engine comes in tomorrow as well. im thinkin by this weekend ill be makin fire forddd
turns out the old engine was knocking because whoever built it, bored it .030 over and put stock pistons back in it.
Quote from: Norm Henderson on March 13, 2010, 05:53:16 AM
turns out the old engine was knocking because whoever built it, bored it .030 over and put stock pistons back in it.
Thats fine as long as you use 30 over rings!!!! lol
Quote from: Mac Henderson on March 13, 2010, 07:31:54 PM
Quote from: Norm Henderson on March 13, 2010, 05:53:16 AM
turns out the old engine was knocking because whoever built it, bored it .030 over and put stock pistons back in it.
Thats fine as long as you use 30 over rings!!!! lol
lol yeah, she'll just run with a lil shimmy
pulled the old motor out and got the new one put back in today. gonna fire it up tomorrow ==bgm forddd
TRUCK IS DONE!!!!!! just put the new posi rearend and the Yukon axle shafts in today. cant wait to take er off roading forddd ==djdj ==bgm
now if you could just figure out why it runs like p00........
runs pretty good actually, just has a cutting out problem
BURNOUTS!!!! I WANT MORE OF THEM!!!!
Quote from: mrcompton on April 11, 2010, 07:16:49 PM
BURNOUTS!!!! I WANT MORE OF THEM!!!!
when i get the ICM problem fixed i promise to do a really nice POSI burnout and film it and put it on here ==bgm forddd
Quote from: Norm Henderson on April 11, 2010, 08:06:52 PM
Quote from: mrcompton on April 11, 2010, 07:16:49 PM
BURNOUTS!!!! I WANT MORE OF THEM!!!!
when i get the ICM problem fixed i promise to do a really nice POSI burnout and film it and put it on here ==bgm forddd
fun fun. PM the post when you do. My dads got a 92 with a 351w aode(yuck) and rear and front lockers. Love lockers. So fun to just smash on it and get the rear loose lol.