i m stumped with mine will spit n spit n flames and stuff but wont stay on will go poof smoke . i m done so is there a shop that fix those?
if it is a reddy heater just clean with air. please see post on reddy heater. ;)
Is there a pressure guage on it?.... your pressure might need to be turned up a little, pretty common. Also mine tends to do this when its really cold, once it warms up it fires up fine
Quote from: xjs3667 on January 18, 2014, 06:40:43 AM
Is there a pressure guage on it?.... your pressure might need to be turned up a little, pretty common. Also mine tends to do this when its really cold, once it warms up it fires up fine
x2
It's a dyno glo work horse. Tsc brand I think. Now it will trip breaker and I m not sure what's next
I ll try the pressure thing and go from there.
Did you figure out this??? Mine was just doing the same thing and I took the 2 air filters out ane cleaned tbem b6 blowing them out with the air compressor and it seems to be working good.
nope cleaned the air filters anjd got new photo cell and spark plug was hoping it fixed but nope stumped
by the way ur describing it sounds like ya need to turn the pressure down a bit when fire shoots out the front of it theres to much fuel being burned excessive fumes ???
How do I turn it down?
fuel filter changed?
did you take the nozzle apart..? take that whole brass piece apart ..inside u will find a stainless "tip" with groves cut in it..
thats what make the fuel come out the nozzle like a "fan pattern" atomises it.. if it is cloged up then it will come out in more of a "straight line" and will make it burn bad. flames out the end and it and make the cell read bad flame and shut down..
dose the motor sound strained?.. seen the vanes in the pump get stuck and actually stahl the whole motor. cause breaked to trip
there a port on back of motor / pump.. . one port will adjust ur pressuer other is for test gauge
the one on the right on the very back of the pump where the air filters r