Any know CMUDFLY? Got a question for him.

[Cannaert]

I am trying to get hold of him as well as another member off the site.  Check out his profile and he has not been on since May 1st.

I got a set of axles form an old bogger that he owned and I am got the axles out of it and I popped the covers of the rear and the there is no stamping on the ring gear for the ratio and the front axle look like the ball joints were changed as well as the u-joints and I just want to know if they were changed or not and what is the gearing in them.

[marshall]

Count the teeth, simple math

[Cannaert]

I KNOW THAT I CAN DO THAT, But it is kind of hard to count the Pinion Gear when its full of fluid.  And I am about to drain it and then dump it back into the axle and end of having something else fall in there with it.  Also the front is complete, Springs and all and I can just move that around and open that one up with ease.

Any ways what I am asking is not the big of a deal to find out from him. 

[CMUDFLY]

Ill call the guy that did them the hole drive train was out of a ex comp bigger I think they where 4:56 but ill check for sher