dana 44 pinion bearing

Started by Nick_gt, February 28, 2013, 03:46:05 AM

Previous topic - Next topic
Print
Go Down Pages1
User actions

Nick_gt

February 28, 2013, 03:46:05 AM
 i have a gm dana 44 that needs the pinion bearing changed. do i have to pull the whole carrier out or can i just do it from the back of the pumkin?

OHEARN.2012

#1
February 28, 2013, 05:15:09 AM
Youll have to pull the carrier to change both of the bearings.
RBS Racing

i bog my bogger not my daily driver

built tough with chevy stuff

Listen Here Boy....I was slinging' mud before you were swimmin' round in your daddy's Nu* sack. Yankee Lake Trucks Gone Wild 2011

marshall

#2
February 28, 2013, 11:45:21 AM
Quote from: OHEARN.2012 on February 28, 2013, 05:15:09 AM
Youll have to pull the carrier to change both of the bearings.
and everything else
chevvv proud member of the wrong crowd chevvv

4x4xdodgeman

#3
February 28, 2013, 10:41:59 PM
put tube seals in at the same time.

Nick_gt

#4
March 01, 2013, 12:02:51 AM
im pretty sure theyre both bad. i can move the pinion all around and front to back

Eroq

#5
March 02, 2013, 12:01:53 AM
Quote from: Nick_gt on March 01, 2013, 12:02:51 AM
im pretty sure theyre both bad. i can move the pinion all around and front to back

gears are probably shot too then...

OHEARN.2012

#6
March 02, 2013, 03:38:32 AM
Quote from: Eroq on March 02, 2013, 12:01:53 AM
Quote from: Nick_gt on March 01, 2013, 12:02:51 AM
im pretty sure theyre both bad. i can move the pinion all around and front to back

gears are probably shot too then...
Agreed. when my pinion bearing went out my whole axle was destroyed.
RBS Racing

i bog my bogger not my daily driver

built tough with chevy stuff

Listen Here Boy....I was slinging' mud before you were swimmin' round in your daddy's Nu* sack. Yankee Lake Trucks Gone Wild 2011
Print
Go Up Pages1
User actions
Powered by EzPortal