Auto 4x4 option

Started by wideopen, November 02, 2013, 10:43:14 AM

Previous topic - Next topic

wideopen

I have a 99 jimmy 4.3/automatic  it's got the 2hi/4hi/4lo/auto4hi setup this not the same as a all wheel drive setup right? The reason I ask is none of the 4x4 lights come on or make any noise underneath the pos but I notice when im turning the front is locked in (the only sounds come from the control module on the pass side kick panel) and I'm kinda stumped I've been through all the wiring and plugs fuse's fluid/filters exc. think I might just pull the front shaft
cant follow me with no jeep

Mudbuster

you have a full time type of case you don't have a 2wd option

wideopen

Quote from: Mudbuster on November 02, 2013, 11:23:05 AM
you have a full time type of case you don't have a 2wd option

It has a button for 2 wheel , I forgot it in my post
cant follow me with no jeep

'the DON'

==wgm

wideopen

It looks as if the po swapped all the electronics trying to diagnose it (all look to be recycled F.A.S parts)
cant follow me with no jeep

J.C.

Time to cut a hole in the floor lol

lilred

check the actuator under the battery tray, make sure it releases. Sounds like your front dif is stuck engaged, easy way to tell is put the truck in 2wd grab the front driveshaft it should spin freely by hand. If it doesnt your front dif is engaged/somethings stuck.

D.I.L.L.I.G.A.F.

Quote from: lilred on November 23, 2013, 01:24:28 AM
check the actuator under the battery tray, make sure it releases. Sounds like your front dif is stuck engaged, easy way to tell is put the truck in 2wd grab the front driveshaft it should spin freely by hand. If it doesnt your front dif is engaged/somethings stuck.


just went through this with my sister trail blazer. Pulled the front drive shaft and still felt like the front end was engaged in 2wd.Turned out it was a stuck acuator on the axle assembly and a sensor on the t-case. Cost her parts and 80bucks labor. Same setup push button 2wd, 4 auto (which she keeps it in all the time), 4hi and 4 low.
Everday Normal Redneck MotherF*cker<br /><br />Start with stock and upgrade when p00 gets broke.

hollywoodhillbilly

Could also be the encoder motor. Theres a sensor in them that has a tendency to go bad

lilred

Yeah pulling the front driveshaft doesn't solve anything, still will do the same thing.

7387chevynut

Quote from: J.C. on November 22, 2013, 10:50:34 PM
Time to cut a hole in the floor lol

X2.............electronics suck.   

Lever on the floor all the way!!
chevvv

Powered by EzPortal