np 208 modification

[nauss]

can anyone tell me if you can swap out an input shaft in a np208. I am basically looking at upgrading from a th350 to a th400. I run a np208 with a sye kit on it and was curious if I can just swap the 28 spline input for a 32??? thanks for helping in advance

[84blazer]

Sure can. Just pay attention where everything goes when you split the t-case in half. Not to bad to do, can be kind of a pain to get everything lined back up getting it back together.

[dirtydog]

Done it a few times now

[Rohde009]

I have a 208 off from a 400 if you need one

[nauss]

Pm sent and thanks again for the info